0
  • Easy to Install Multi-sector Antenna Design High Power Broadband Power Amplifier Multi-band Interference
  • Easy to Install Multi-sector Antenna Design High Power Broadband Power Amplifier Multi-band Interference
  • Easy to Install Multi-sector Antenna Design High Power Broadband Power Amplifier Multi-band Interference

  • The omnidirectional jammer interferes with the satellite navigation signal of the drone by transmitting electromagnetic waves or blocks the communication link between the drone and the remote control, so that the drone has the effect of forced landing or return. The omnidirectional jammer is composed of multi-channel digital signal source, high-power broadband power amplifier, broadband omnidirectional antenna, power supply module, etc. The jammer supports a variety of modulated signal outputs, and the broadband omnidirectional antenna realizes omnidirectional radiation of high-power interference signals.
  • $ Inquiry
  • 0 in Stock NowJR-HN27
  • Group

    Default

  • QUANTITY

  • Contact Online

Detection Range

≥2km(0.1W radiation source)

Jamming Frequency Band

Drone image transmission/Data transmission/Remote control frequency band

Jamming Angle

360°omnidirectional

Inteference To Signal Ratio

>10:1

Jamming Effective Time

≤3s

Communication Interface

1 RJ45、10M/100M/1000M Adaptive Ethernet port

Power Supply

AC220V±10%,50Hz

You May Be Intersted
small and slow targets, as well as pedestrians and vehicles. It can apply warning and target indication, and can provide real-time and accurate target trajectory information.

It can apply warning and target indication, and can provide real-time and accurate target trajectory information

This air surveillance radar is used for the detection of low altitude, small and slow targets, as well as pedestrians and vehicles. It can apply warning and target indication, and can provide real-time and accurate target trajectory information.

Inquiry
Hacking into the "Black Fly" UAV navigation system, so as to achieve interception control of UAVs that require flight control using the navigation system, so that they cannot fly into protected areas

Deceptive interference is carried out on the satellite navigation coordinate information received by the UAV using satellite navigation and positioning, and the no-fly zone projection or area denial function is realized.

By radiating low-power regenerative navigation satellite signals (power no more than 10dBm), the "black fly" UAV navigation system is invaded, so as to achieve the interception and control of the UAV that needs to use the navigation system for flight control, so that it cannot fly into the protected area and ensure the low-altitude safety of the area. The equipment is designed with portable pull-rod box, which can be flexibly deployed in key areas of the field.

Inquiry
The UAV detection and countermeasure system is scientifically combined, which is mainly used for the detection, identification and interference countermeasures of the UAV in the flight state

The system features drone detection and early warning, model identification, and countermeasures for expulsion.

The system adopts the design of detecting and fighting as a whole, scientifically combining the drone detection and countermeasure system, mainly used for detecting and recognizing the drone in flight status and jamming and countermeasure, which can make the drone hovering in place, forced landing or returning to the flight, effectively preventing the drone from entering into the defense zone and guaranteeing the safety of low altitude airspace, with good detection and countermeasure performance, long working distance, no need to be guarded by the personnel, and automatically carrying out the detection and countermeasure of the drone.

$180400
Adaptable Low Cost High Refresh Rate Strong Recognition Ability

The RF scan 3D security radar adopts 3D scanning technology, aiming at the three-coordinate three-dimensional space surveillance of low-altitude, ground targets, all-round and high-elevation coverage

The RF scan 3D security radar adopts 3D scanning technology, aiming at the three-coordinate three-dimensional space surveillance of low-altitude, ground targets, all-round and high-elevation coverage, and is mainly responsible for the real-time reconnaissance of aircraft, ground personnel, vehicles and other targets in the surrounding area, finds and tracks the target, and output or report the target information to the specified user. The radar supports three erection modes: fixed, vehicle-mounted and portable, and is flexibly suitable for various low-altitude and ground security application scenarios.

Inquiry
It monitors the health and safety status of the received navigation satellite signals, identifies and isolates jamming signals and spoofing signals, and improves the security, stability and anti-attack ability of the timing system

Under the condition of full frequency suppression interference, the signal required for accuracy can still be synchronized

• Automatically switch between synchronization hold mode and denial sustain mode based on the status of input signals. • Real-time monitoring of satellite navigation signals at the installation location of the timing equipment • Automatically isolate non-secure GPS L1 and BDS B1 signals . • Monitor output signal status and log alerts for abnormal output signals. • Capable of remotely receiving command . • Resistant to meaconing and spoofing signals.

$12490
The radar host is mainly composed of four independent radar fronts and an integrated control box, which is mainly used for the detection, early warning and target indication of UAVs in the monitoring area

and 360 degree all-round coverage.

The radar host is mainly composed of four independent radar fronts and an integrated control box, which is mainly used for the detection, warning and target indication of UAVs in the monitoring area, providing real-time, accurate and continuous air situation and target information for the monitoring system and providing security.

Inquiry
The measuring terminal uses the radio spectrum monitoring system to passively intercept the image transmission signal and remote control signal between the UAV and the remote control to realize the passive detection of the UAV

The detection end passively intercepts the signal between the drone and the remote control to realize the detection of the drone

The detection terminal uses the radio spectrum monitoring system to passively intercept the image transmission signal and the remote control signal between the UAV and the remote control to realize the passive detection of the UAV. The strike end is mainly for the compulsory control of the UAV or the flying model in the flying state, and the contact between the UAV and the remote control person is cut off at a distance. The interceptor can force the UAV to land or return to the air to ensure the safety of the low-altitude airspace in the region.Cut off all signal communication between the drone and the controller, and the ground controller of the drone can not receive aerial videos and pictures. The drone is unable to locate, forcing the drone to land, hover, or turn back.

$52050
Strong Penetration Indoor Structure Simulation Reconstruction  Multi-target Real-time Positioning  Intelligent Recognition

which can penetrate non-metallic obstacles such as building walls to detect multiple personnel targets behind it, and quickly obtain information such as 3D imaging, 2D coordinates, attitude, quantity of targets and indoor structure.

Three Dimensional Imaging Through Wall Radar 43 is a 3D imaging penetrating reconnaissance equipment, which can penetrate non-metallic obstacles such as building walls to detect multiple personnel targets behind it, and quickly obtain information such as 3D imaging, 2D coordinates, attitude, quantity of targets and indoor structure.

$55700
Shop by Categories